BIS Certification for Commercial Electric Rinsing Sinks in India products are subject to mandatory BIS Compulsory Registration Scheme (CRS) requirements in India. Every manufacturer and importer must obtain a valid BIS CRS registration for each model before the product can be manufactured, imported, or sold in the Indian market. Non-compliance attracts penalties including product seizure, market withdrawal, and prosecution under the BIS Act 2016.
This guide covers the applicable Indian Standards, mandatory safety testing requirements, the step-by-step CRS registration process, documentary requirements, and the most critical compliance pitfalls for this product category in 2026.
📜 Applicable Indian Standards
The following Indian Standards apply to this product category under the BIS CRS framework:
- IS/IEC 60335-2-58 — Particular requirements for commercial electric rinsing sinks
- IS/IEC 60335-1 — General requirements for safety of household and similar electrical appliances
- IS 13252 (Part 1) — Indian adaptation of IEC 60335-1
📌 Commercial rinsing sinks combine water and electricity in high-throughput environments. BIS testing for this category places critical emphasis on earth continuity, moisture ingress resistance, and the safety of the immersed heating element under both normal and low-water fault conditions.
🔬 Mandatory Safety Tests
BIS-approved laboratories evaluate the following key areas during safety testing for this product category:
Electrical Safety
Insulation resistance, dielectric strength, leakage current, earth continuity, and input power verification.
Water and Moisture
Moisture ingress resistance, heater element performance under low-water conditions, and IPX rating compliance.
Heating Element
Element temperature under normal, low-water, and dry-run fault conditions; thermal cut-out calibration.
Mechanical
Basin material integrity, mounting stability, and drainage system safety under continuous commercial use.
📋 Step-by-Step BIS CRS Registration Process
- Standard ConfirmationVerify the product maps to IS/IEC 60335-2-58. Combined units with dishwashing functionality may attract additional standard requirements.
- Appoint AIRForeign manufacturers must appoint an AIR in India before the BIS CRS application is filed.
- Sample TestingSubmit production-representative units to a BIS-approved lab. Commercial kitchen equipment testing typically takes 4-6 weeks.
- Online ApplicationSubmit Form VI, test report, factory documents, photographs, trademark certificate, and AIR letter on BIS Manak Online portal.
- Query ResolutionCommon BIS queries relate to dry-run heater protection data, earth continuity path documentation, and factory quality system records.
- R-Number GrantBIS issues the R-number upon approval. Mark on the appliance, packaging, and installation manual.
- RenewalValid for 2 years. Changes to heating element, basin material, or thermostat require re-testing.
📄 Documents Required
- Completed BIS Form VI and declaration of conformity
- Test report as per IS/IEC 60335-2-58 and IS 13252 (Part 1) from BIS-approved laboratory
- Factory registration and address proof
- Trademark registration certificate
- AIR appointment letter (for foreign manufacturers)
- Product photographs with compliance label placement
- Technical specification sheet (rated voltage, wattage, basin capacity, temperature range)
- Installation and user manual in English and/or Hindi
☠ Common Rejection Reasons
Frequent rejection causes include insufficient dry-run protection test data for the heating element, earth continuity path not verified through the full water-contact circuit, moisture ingress test failure, and model number discrepancies between the test report and the registration application.
🏭 Special Considerations for Importers
Commercial rinsing sinks imported for hotels, restaurants, and institutional kitchens must carry a valid BIS CRS R-number on both the unit and its packaging. BIS enforcement in the commercial kitchen equipment sector is increasing, particularly for products sold through hospitality supply chains and e-procurement platforms.
Commercial Rinsing Sink BIS Certification Partner
Global Approbation handles BIS CRS registration for commercial electric rinsing sinks — from IS/IEC 60335-2-58 testing to R-number grant.
BIS CRS Services Talk to Our Team