
Home routers, mesh Wi-Fi systems and enterprise access points use 2.4 GHz, 5 GHz and now 6 GHz radios. Each model needs WPC ETA, and routers may also fall under TEC MTCTE. This guide covers the bands involved, the RF test standards, the other Indian approvals that usually apply, and the mistakes that most often delay approval. For the full service, see our WPC ETA approval services.
Quick answer: Yes. Routers and access points transmit in de-licensed Wi-Fi bands and obtain ETA by self-declaration. The fee is Rs 10,000 per application and the ETA remains valid unless revoked.
📡 Do Wi-Fi Routers & Access Points Need WPC Approval?
Yes. Routers and access points transmit in de-licensed Wi-Fi bands and obtain ETA by self-declaration. Tri-band and Wi-Fi 6E/7 models must also cover the 6 GHz band (5945–6425 MHz), which India de-licensed in January 2026.
📶 Radio Bands & Technologies
Wi-Fi 2.4 GHz
802.11b/g/n/ax in 2400–2483.5 MHz. Tested to ETSI EN 300 328.
Wi-Fi 5 GHz
802.11a/n/ac/ax in the de-licensed 5 GHz sub-bands. Tested to ETSI EN 301 893 (and EN 300 440 / EN 302 502 where the 5.8 GHz band is used).
Wi-Fi 6 GHz
5945–6425 MHz, de-licensed by GSR 47(E) of 20 January 2026 and now selectable on SARAL Sanchar. Tested to ETSI EN 303 687.
Outdoor access points
Outdoor units must stay within the outdoor power limits for each band. Indoor-only bands cannot be enabled in outdoor firmware.
🔬 RF Test Standards & Reports
WPC needs an RF test report for every transmitter in the product. Reports are typically prepared against the harmonised ETSI standards below, at an ISO/IEC 17025-accredited lab, with the firmware set to India’s bands and power limits.
- ETSI EN 300 328 — 2.4 GHz
- ETSI EN 301 893 — 5 GHz
- ETSI EN 303 687 — 6 GHz
- ETSI EN 301 489-1/-17 — EMC (supporting)
🧾 Other Approvals for Wi-Fi Routers & Access Points
WPC ETA covers only the radio. Depending on the product, these approvals usually run alongside it:
- TEC MTCTE: Routers and customer-premises equipment that connect to a telecom network may need TEC Mandatory Testing and Certification (MTCTE). Check the current MTCTE product list for your interfaces.
- BIS CRS for the charger/adapter: External power adapters supplied with the product are registered separately under BIS CRS (IS 13252 Part 1).
🛠️ Step-by-Step WPC ETA Process
- Map every radioList each transmitter in the wi-fi routers & access points with its band, technology and maximum output power.
- Check India settingsConfirm firmware limits channels and power to the Indian de-licensed bands.
- RF testingTest each radio to the applicable ETSI standard at an ISO/IEC 17025-accredited lab, or check that existing reports cover the Indian settings.
- Register on SARAL SancharCreate the applicant profile (Indian entity or authorised Indian representative, with GST, PAN and IEC details).
- File the self-declarationUpload the RF test report, technical documents and authorisation, and pay the Rs 10,000 fee.
- Download the ETAUnder DoT’s September 2024 OM, the ETA can be downloaded once the application is successfully submitted.
📄 Documents Required
- RF test report covering every radio in the product
- Technical specifications: frequency bands, technology and maximum output power for each radio
- User manual and product photographs or label artwork showing the model number
- Authorisation from the manufacturer, where an Indian representative applies
- Applicant registration details on SARAL Sanchar (GST, PAN, IEC)
⚠️ Common Pitfalls for Wi-Fi Routers & Access Points
- Firmware enables channels or power levels beyond the Indian limits, especially at 5.8 GHz and 6 GHz.
- Mesh satellites and main router treated as one model when their radios differ.
- 6 GHz band not covered in the test report for Wi-Fi 6E/7 models.
- MTCTE overlooked because the WPC ETA was already in place.
❓ Frequently Asked Questions
Can I sell a Wi-Fi 6E router in India now?
Yes, since GSR 47(E) of 20 January 2026 de-licensed 5945–6425 MHz. The 6 GHz radio must be tested and declared in the ETA.
Does each mesh node need its own ETA?
If the satellite node is electrically different from the main router, yes.
Is MTCTE the same as WPC?
No. WPC covers radio use; TEC MTCTE covers telecom network equipment. Some routers need both.
How much does WPC ETA cost and how long is it valid?
The SARAL Sanchar fee is Rs 10,000 per application, and DoT states that an ETA is valid for life unless revoked by the WPC Wing. Testing costs are separate.
How long does WPC ETA by self-declaration take?
Once the RF test report is ready, the application is filed on SARAL Sanchar and the ETA can be downloaded after successful submission and fee payment. Most of the time goes into testing.
WPC ETA for Wi-Fi Routers & Access Points — Handled End to End
Global Approbation maps your radios, coordinates RF testing, files on SARAL Sanchar and manages the related BIS and DoT approvals, so your Wi-Fi routers can clear customs without delay.
Talk to Our WPC Team WPC ETA Services